Structural Engineering and Mechanics

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

A constitutive model for concrete confined by steel reinforcement and carbon fiber reinforced plastic sheet

  • Li, Yeou-Fong (Department of Civil Engineering, National Taipei University of Technology) ;
  • Fang, Tsang-Sheng (Department of Civil Engineering, National Taiwan University)
  • Received : 2003.04.09
  • Accepted : 2004.01.19
  • Published : 2004.07.25
⟨ Previous Next ⟩

Abstract

In this paper, we modify the L-L model (Li et al. 2003) and extend the application of this model to concrete confined by both steel reinforcement and CFRP. Thirty-six concrete cylinders with a dimension of ${\varphi}30{\times}60$ cm were tested to verify the effectiveness of the proposed model. The experimental test results show that different types of steel reinforcement have a great effect on the compressive strength of concrete cylinders confined by steel reinforcement, but the different types of steel reinforcement have very little effect on concrete cylinders confined by both steel reinforcement and CFRP. Compared with the stress-strain curves of confined concrete cylinders, we can conclude that the proposed model can provide more effective prediction than others models.

Keywords

References

  1. Ahmad, S.H. and Shah, S.P. (1986), "Orthotropic model of concrete for tri-axial stresses", J. Struct. Eng., ASCE, 112, 165-181. https://doi.org/10.1061/(ASCE)0733-9445(1986)112:1(165)
  2. Balmer, G.G. (1949), "Shearing strength of concrete under high tri-axial stress-computation of Mohr's envelope as a curve", Structural Research Laboratory Report No. SP-23, U.S. Bureau of Reclamation.
  3. Caltrans (1994), The Northridge Earthquake-Post Earthquake Investigation Report, Division of Structures, Caltrans.
  4. Considire, A. (1903), Experimental Researches Reinforced Concrete, L.F. Moisseiff, translator, McGraw-Hill, New York.
  5. Fujii, M. and Kobayashi, K. (1978), "A study on the application of a stress-strain relation of confined concrete", Proceedings, JCA Cement and Concrete, Japan Cement Association, Tokyo, Japan, 42, 429-432.
  6. Goodman, R.E. (1989), Introduction to Rock Mechanics, John Wiley & Sons, N.Y.
  7. Hognestad, E. (1951), "A study of combined bending and axial load in reinforced concrete members", Engineering Experimental Station, University of Illinois, Bulletin Series No. 399.
  8. Hoshikuma, J., Kawashima, K., Nagaya, K. and Taylor, A.W. (1997), "Stress-strain model for confined reinforced concrete in bridge piers", J. Struct. Eng., ASCE, 123, 624-633. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:5(624)
  9. Hosotani, M., Kawashima, K. and Hoshikuma, J. (1998), "A stress-strain model for concrete cylinders confined by carbon fiber sheets", Civil Engineering, JSCE, 39(592), 37-52. (in Japanese)
  10. Hosotani, M. and Kawashima, K. (1999), "A stress-strain model for concrete cylinders confined by both carbon fiber sheets and hoop reinforcement", Civil Engineering, JSCE, 43(620), 25-42. (in Japanese)
  11. Karabinis, A.I. and Rousakis, T.C. (2001), "Carbon F.R.P. confined concrete elements under axial load", FRP Composite in Civil Engineering, CICE, 309-316.
  12. Kent, D.C. and Park, R. (1971), "Flexural members with confined concrete", J. Struct. Div., ASCE, 97, 1969-1990.
  13. Lam, L. and Teng, J.G. (2001), "A new stress-strain model for FRP-confined concrete", FRP Composite in Civil Engineering, CICE, 283-292.
  14. Li, Y.-F., Lin, C.-T. and Sung, Y.-Y. (2003), "A constitutive model for concrete confined with carbon fiber reinforced plastics", Mechanics of Materials, 35, 603-619. https://doi.org/10.1016/S0167-6636(02)00288-0
  15. Maguruma, H., Watanabe, S. and Tanaka, S. (1978), "A stress-strain model of confined concrete", Proc., JCA Cement and Concrete, Japan Cement Association, Tokyo, Japan, 34, 429-432.
  16. Mander, J.B., Priestley, M.J.N. and Park, R. (1988a), "Theoretical stress-strain model for confined concrete", J. Struct. Div., ASCE, 114, 1804-1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804)
  17. Mander, J.B., Priestley, M.J.N. and Park, R. (1988b), "Observed stress-strain behavior of confined concrete", J. Struct. Div., ASCE, 114, 1827-1849. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1827)
  18. Mirmiran, A. and Shahawy, M. (1997), "Behavior of concrete columns confined by fiber composites", J. Struct. Eng., ASCE, 123, 583-590. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:5(583)
  19. Nagaya, K. and Kawashima, K. (1999), "Stress-strain model for tied reinforced concrete columns confined by carbon fiber sheets", J. Civ. Eng., JSCE, 43, 25-42.
  20. Newman, K. and Newman, J.B. (1971), "Failure theories and design criteria for plain concrete", Proc. of the Int. Civil Eng. Material Conf. on Structural, Solid Mechanics, and Engineering Design, Wiley Interscience, N.Y., 936-995.
  21. Park, R., Priestley, M.J.N. and Gill, W.D. (1982), "Ductility of square-confined concrete columns", J. Struct. Div., ASCE, 108, 929-950.
  22. Priestley, M.J.N., Seible, F. and Calvi, G.M. (1996), Seismic Design and Retrofit of Bridges, John Wiley & Sons Inc., N.Y.
  23. Richart, F.E., Brandtzaeg, A. and Brown, R.L. (1928), "A study of the failure of concrete under combined compressive stresses", Engineering Experimental Station, University of Illinois, Bulletin No. 185.
  24. Richart, F.E., Brandtzaeg, A. and Brown, R.L. (1929), "The failure of plain and spirally reinforced concrete in compression", Engineering Experimental Station, University of Illinois, Bulletin No. 190.
  25. Saatcioglu, M. and Razvi, S.R. (1992), "Strength and ductility of confined concrete", J. Struct. Div., ASCE, 118, 1590-1607. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:6(1590)
  26. Sheikh, S.A. and Uzumeri, S.M. (1980), "Strength and ductility of tied concrete columns", J. Struct. Div., ASCE, 106, 1079-1102.
  27. Sheikh, S.A. and Uzumeri, S.M. (1982), "Analytical model for concrete confinement in tied columns", J. Struct. Div., ASCE, 108, 2703-2722.
  28. Wang, P. and Cheong, K.K. (2001), "RC columns strengthened by FRP under uniaxial compression", FRP Composite in Civil Engineering, CICE, 327-334.
  29. Xiao, Y. and Wu, H. (2001), "Concrete stub columns confined by various types of FRP jackets", FRP Composite in Civil Engineering, CICE, 293-300.

Cited by

  1. A constitutive model of concrete confined by steel reinforcements and steel jackets vol.32, pp.1, 2005, https://doi.org/10.1139/l04-093
  2. Theoretical and experimental studies on repaired and rehabilitated reinforced concrete frames vol.34, pp.8, 2007, https://doi.org/10.1139/l07-012
  3. Modeling the confined compressive strength of hybrid circular concrete columns using neural networks vol.8, pp.5, 2004, https://doi.org/10.12989/cac.2011.8.5.597
  4. Determination of plastic hinge properties for static nonlinear analysis of FRP-strengthened circular columns in bridges vol.10, pp.5, 2012, https://doi.org/10.12989/cac.2012.10.5.435