References
- Q. Q. Ni and E. Jinen, 'Fracture behavior and acoustic emission in bending test on single-fiber composites', Eng. Fracture Mech., Vol. 56, No.6, pp. 779-796, (1997) https://doi.org/10.1016/S0013-7944(97)00001-5
- J. M. Park, Y. M. Kim and J. W. Kim, 'Interfacial aspects of electrodeposited carbon fiber-reinforced epoxy composites using monomeric and polymeric coupling agents', J. Colloid Interface Sci., Vol. 231, No.1, pp. 114-128, (2000) https://doi.org/10.1006/jcis.2000.7113
- T. Grubb and Z. F. u. 'Single-fiber polymer composites: Part I interfacial shear strength and stress distribution in the pullout test', J. Mater. Sci., Vol. 29, No.1, pp. 189-202, (1994) https://doi.org/10.1007/BF00356593
- M Kharrat, A Chateauminois, L. Carpentier and P. Kapsa, 'On the interfacial behaviour of a glass/epoxy composite during a microindentation test: assessment of interfacial shear strength using reduced indentation curves', Compos. Part A, Vol 28, No.1, pp. 39-46, (1997) https://doi.org/10.1016/S1359-835X(96)00092-9
- D. Rouby, 'Acoustic emission: a micro-investigation technique for interface mechanisms in fiber composites', J. Acoustic Emission, Vol 9, No.2, pp. 117-121, (1990)
- G. J. Farrow, J. D. H. Hughes and M. Darby, 'Acoustic emission from single carbon fibers and model microcomposites', J. Phys. D: Appl Phys., Vol 27, No.3, pp. 644-651, (1994)
- X. Lu, W. Sachse and I. Grabec, 'Use of an automatic modeler and a small receiver array for acoustic emission (AE) source location', Ultrasonics, Vol 36, No.5, pp. 539-547, (1998)
- S. I. Lee, J. M. Park, D. W. Shin and D. J. Yoon, 'Interfacial properties of glass fiber/brittle-ductile dual-matrix composites using micromechanical technique and acoustic emission', Polym. Compos., Vol 20, No.1, pp. 19-28, (1999)
- D. B. Marshall and W. C. Oliver, 'An introduction method for measuring residual stress in fiber reinforced ceramics', Mater. Sci. Eng., Vol. A126, No.1, pp. 95-103, (1990)
- J. M. Park, W. G. Shin and D. J. Yoon, 'Interfacial aspects of two basalt and SiC fiber reinforced epoxy composites using fragmentation technique and acoustic emission', Compos. Sci. Technol., Vol. 59, No.3, pp. 355-370, (1999) https://doi.org/10.1016/S0266-3538(98)00085-2
- A Manor and R. B. Clough, 'In-situ determination of fiber strength and segment length in composites by means of acoustic emission', Compos. Sci. Technol., Vol. 45, No.1, pp. 73-81, (1992) https://doi.org/10.1016/0266-3538(92)90124-L
- J. Eisenblatter, 'Acoustic emission analysis: Introduction, present status and future development, DGM Informations gesell schaft-Vlerlag, Oberursel., (1998)
- S. M. Ziola and M. R. Gorman, 'Source location in thin plates using cross-correlation', J. Acoustic Soc. Amer., Vol 90, pp. 2551-2556, (1991)
- M. Surgeon and M. Wevers, 'One sensor linear location of acoustic emission events using plate wave theories', Mater. Sci. Eng., Vol. A265, No.2, pp. 254-261, (1999) https://doi.org/10.1016/S0921-5093(98)01142-3
- A. N. Netravali, Z. F. Li and W. Sache, 'Determination of fiber/matrix interfacial shear strength by and acoustic emission techniques', J. Mater. set, Vol. 26, pp. 6631-6638, (1991)
- A R. Baker, 'The single fiber composite acoustic emission measurement system', MS Thesis, Cornell University, U. S. A, (1991)
- H. Jeong and Y. S. Jang, 'Wavelet analysis of plate wave propagation in composite laminates', Compos. Structures, Vol. 49, No. 4, pp. 443-450, (2000) https://doi.org/10.1016/S0263-8223(00)00079-9
- A. Kelly and W. R. Tyson, 'Tensile properties of fiber reinforced metals: copper/ tungsten and copper/molybdenum', Mech. Phys. Solids, Vol. 13, pp. 329-350, (1965)
- L. T. Drzal, 'The effect of polymeric matrix mechanical properties on the fiber-matrix interfacial shear strength', Mater. Sci. Eng., Vol 21, pp. 289-293, (1990)
- N. S. Choi, and K. Takahashi, 'Characterization of the damage process in short-fiber/thermoplastic composites by acoustic emission', J. Mater. sci, Vol. 33, No.9, pp. 2357-2363, (1998) https://doi.org/10.1023/A:1004347623040
- 'Standard test method for tensile strength and Young's modulus for high-modulus single-filament materials', ASTM D 3379-75, Reapproved, (1989)
- J. M. Park, S. I. Lee, J. w. Kim and D. J. Yoon, 'Interfacial properties of electrodeposited carbon fibers/epoxy composites using electro-micromechanical techniques and nondestructive evaluation', J. Colloid Interface sci, Vol 237, No. 1, pp. 80-90, (2001)