참고문헌
- Attia, O., Kinloch, A. J. and Matthews, F. L., 2001, 'Modelling the Fatigue Life of Polymer Matrix Fibre-Composite Components,' Composites Science and Technology, Vol. 61, No. 15, pp. 2273-2283 https://doi.org/10.1016/S0266-3538(01)00121-X
- Bell, G. R., Cook, D. C. and Rogers, D. D., 1979, 'Microtoming ; An Emerging Tool for Analyzing Polymer Structures,' Plast. Eng., No. 35, pp. 18
- Harik, V. M., 2000, 'Low Cycle Fatigue of Unidirectional Laminates : Stress Ratio Effects,' Journal of Engineering Materinals and Technology, Vol. 122, No. 4, pp. 415-419 https://doi.org/10.1115/1.1289024
- Himmel, N., 2002, 'Fatigue Life Prediction of Laminated Polymer Matrix Composites, 'International Journal of Fatigue, Vol. 24, No. 2, pp. 349-360 https://doi.org/10.1016/S0142-1123(01)00090-1
- Jack, R. V. and Eyassu Woldesenbet, 2001, 'Fiber Orientation Effects on High Strain Rate Properties of Graphite/Epoxy Composites,' Journal of Composite Materials, Vol. 35, No. 6, pp. 509-521 https://doi.org/10.1177/002199801772662136
- Karger, K. J. and Friedrich, K., 1988, Advancing with Composites Conf., Milan, pp. 639
- Lim, J. K. and Kim, Y. J., 1993, 'A Study on Fatigue Properties of GFRP in Synthetic Sea Water, 'Trans. of KSME, Vol. 17, No. 6, pp. 1351-1360
- Lim, J. K. and Kim, Y. J., 2001, 'Evaluation of Inhomogeneous Deformation and Stress Concentration in Polymer Composites Injection Weld by means of Thermoelastic Techniques, 'KSME International Journal, Vol. 15, No. 12, pp. 1616-1622
- Noda, K., Takahara, A. and Kajiyama, T., 2001, 'Fatigue Failure Mechanisms of Short Glass-Fiber Reinforced Nylon 66 Based on Nonlinear Dynamic Viscoelastic Measurement, 'Polymer, Vol. 42, pp. 5803-5811 https://doi.org/10.1016/S0032-3861(00)00897-1
- Song, D. Y. and Otani, N., 1998, 'Approximate Estimation of Fatigue Strength of Polymer Matrix Composites by Material Properties, 'Materials Science and Engineering A, Vol. 254, No. 1, pp. 200-206 https://doi.org/10.1016/S0921-5093(98)00703-5
- Young, R. T. and Baird, D. G., 2000, 'The Influence of Processing Variables on Injection Molded in Situ Composites Based on Polyphenylene Sulfide and a Melt Processable Glass,' Composities Part B: Engineering, Vol. 31, pp. 209-221 https://doi.org/10.1016/S1359-8368(99)00080-3