DOI QR코드

DOI QR Code

A Study on Ozone Generation Characteristic using Ba-Ti-Si Ceramic Tube

Ba-Ti-Si 세라믹 방전관의 오존 발생 특성 연구

  • 이동훈 (경남대학교 전기공학과 대학원) ;
  • 박홍재 (경남대학교 전기공학과 대학원) ;
  • 박재윤 (경남대학교 전기전자공학부)
  • Published : 2003.07.01

Abstract

This paper is to be researched into ozone generation character of Bi-Ti-Si type high dielectric yield ceramic catalyst discharge tube. And conditions of basic experiment are the outside diameter of discharge tube : 52 mm, the length of discharge tube : 350 mm, the frequence : 900 Hz, the temperature of cooling water : 25 $^{\circ}C$, quantity of flow : 5, 10, 20 l/min, pressure : 1.2, 1.4, 1.6 atm, and distance of discharge gap : 0.4, 0.6, 0.8 mm. Ozone generation characteristics were measured to consumption power. At quantity of flow : 20 l/min, discharge gap : 0.6 mm, pressure : 1.6, and consumption power : 150 W, Maximum ozone generation efficiency of 175 g/kWh was obtained. Maximum ozone generation efficiency was measured below the flow quantity of 20 l/min at below pressure of 1.6 atm. However, Maximum ozone generation efficiency was measured over the flow quantity of 20 l/min at over pressure of 1.6 atm.

Keywords

References

  1. T. IEE Japan v.117-A no.11 放電重疊法によるオゾン生成の高收率化 岸田治夫
  2. 靜電氣學會誌 v.7 オゾナイザにおけるオゾン生成機構と今後の課題 井 關昇
  3. 한국조명전기학회 논문집 오존 발생기를 이용한 고도 정수 처리기술 동향 및 전망 이형호;이광식
  4. Ozone Science and Engineering v.19 Experimental study on ozone synthesis via dielectric barrier dischanges Moo Been Chang
  5. 전기전자재료학회 논문지 v.10 no.3 BaTiO₃세라믹스의 절연 파괴거동에 미치는 기공의 크기와 기공율의 영향 남효덕;우동찬
  6. 전기전자재료학회 논문지 v.15 no.1 비선형 특성을 갖는 (Sr · Ca)TiO계 세라믹의 미세구조 및 유전 특성 최운식;강재운;박철하 https://doi.org/10.4313/JKEM.2002.15.1.024
  7. 전기전자재료학회 논문지 v.15 no.1 ZnTiO₃계 마이크로파형 유전체 세라믹스의 저온소결에 관한 연구 이지형;방재철

Cited by

  1. A Characteristic Analysis of Ozone Generator Using the Al2O3Ceramic Dielectric According to Gas Type(O2/Air) vol.28, pp.5, 2014, https://doi.org/10.5207/JIEIE.2014.28.5.076