Abstract
This paper proposes a 10 ${\mu}{\textrm}{m}$ thick oxide air-bridge structure which can be used as a substrate for RF circuits. The structure was fabricated by anodic reaction, complex oxidation and rnicrornachining technology using TMAH etching. High quality films were obtained by combining low temperature thermal oxidation (50$0^{\circ}C$, 1 hr at $H_2O$/O$_2$) and rapid thermal oxidation (RTO) process (105$0^{\circ}C$, 2 min). This structure is mechanically stable because of thick oxide layer up to 10 ${\mu}{\textrm}{m}$ and is expected to solve the problem of high dielectric loss of silicon substrate in RF region. The properties of the transmission line formed on the oxidized porous silicon (OPS) air-bridge were investigated and compared with those of the transmission line formed on the OPS layers. The insertion loss of coplanar waveguide (CPW) on OPS air-bridge was (about 1 dB) lower than that of CPW on OPS layers. Also, the return loss of CPW on OPS air-bridge was less than about - 20 dB at measured frequency region for 2.2 mm. Therefore, this technology is very promising for extending the use of CMOS circuitry to higher RF frequencies.
본 논문에서는 실리콘 기판상의 전송선로 특성을 개선하기 위하여 표면 마이크로머시닝 기술과 새로운 산화법(H₂O/O₂ 분위기에서 500℃, 1시간 열산화와 1050℃, 2 분간 RTO(Rapid Thermal Oxidation) 공정)을 이용하여 10 ㎛ 두께의 다공질 실리콘 산화막(oxidized porous silicon:OPS) air-bridge 기판 위에 공면 전송선로(Coplanar Waveguide:CPW)를 제작하였다. 간격이 40 ㎛ 신호선이 20 ㎛ 전송선 길이가 2.2 mm인 CPW air-bridge 전송선의 삽입손실은 4 GH에서 -0.28 dB이며, 반사손실은 -22.3 유를 나타내었다. OPS air-bridge 위에 형성된 CPW의 손실이 OPS층 위에 형성된 CPW의 삽입손실보다 약 1 dB 정도 적은 것을 보여주었으며, 반사손실은 35 GHz 범위에서 약 -20 dB를 넘지 않고 있다. 이와 같은 결과로부터 두꺼운 다공질 실리콘 멤브레인 및 air-bridge 구조는 고 저항 실리콘 집적회로 공정에서 고성능, 저가의 마이크로파 및 밀리미터파 회로 응용에 충분히 활용 될 수 있으리라 기대된다.