DOI QR코드

DOI QR Code

Seismic assessment of transfer plate high rise buildings

  • Su, R.K.L. (Department of Civil Engineering, The University of Hong Kong) ;
  • Chandler, A.M. (Department of Civil Engineering, The University of Hong Kong) ;
  • Li, J.H. (Department of Civil Engineerig, The University of Hong Kong) ;
  • Lam, N.T.K. (Department of Civil & Environmental Engineering, The University of Melbourne)
  • Received : 2001.08.14
  • Accepted : 2002.07.11
  • Published : 2002.09.25

Abstract

The assessment of structural performance of transfer structures under potential seismic actions is presented. Various seismic assessment methodologies are used, with particular emphasis on the accurate modelling of the higher mode effects and the potential development of a soft storey effect in the mega-columns below the transfer plate (TP) level. Those methods include response spectrum analysis (RSA), manual calculation, pushover analysis (POA) and equivalent static load analysis (ESA). The capabilities and limitations of each method are highlighted. The paper aims, firstly, to determine the appropriate seismic assessment methodology for transfer structures using these different approaches, all of which can be undertaken with the resources generally available in a design office. Secondly, the paper highlights and discusses factors influencing the response behaviour of transfer structures, and finally provides a general indication of their seismic vulnerability. The representative Hong Kong building considered in this paper utilises a structural system with coupled shear walls and moment resisting portal-frames, above and below the TP, respectively. By adopting the wind load profile stipulated in the Code of Practice on Wind Effects: Hong Kong-1983, all the structural members are sized and detailed according to the British Standards BS8110 and the current local practices. The seismic displacement demand for the structure, when built on either rock or deep soil sites, was determined in a companion paper. The lateral load-displacement characteristic of the building, determined herein from manual calculation, has indicated that the poor ductility (brittle nature) of the mega-columns, due mainly to the high level of axial pre-compression as found from the analysis, cannot be effectively alleviated solely by increasing the quantity of confinement stirrups. The interstorey drift demands at lower and upper zones caused by seismic actions are found to be substantially higher than those arising from wind loads. The mega-columns supporting the TP and the coupling beams at higher zones are identified to be the most vulnerable components under seismic actions.

Keywords

References

  1. British Standards Institution (BSI) (1985), Code of Practice for Design and Construction (BS8110 Part 2), British Standard, Structural Use of Concrete.
  2. Buildings Authority Hong Kong, HKSAR (1987), Code of Practice for Structural Use of Concrete.
  3. Buildings Department, HKSAR (1998), Building Construction in Hong Kong.
  4. Buildings Development Department (1983), Code of Practice on Wind Effects : Hong Kong-1983, Government of Hong Kong, Hong Kong.
  5. Calvi, G.M. and Pavese, A. (1995), Displacement Based Design of Building Structures. European Seismic Design Practice, Balkema, Rotterdam, 127-132.
  6. Chan, H.C., Pan, A.D.E., Pam, H.J. and Kwan, A.K.H. (1998a), "Seismic detailing of reinforced concrete buildings with relevance to Hong Kong design practice (Part I)", Transactions of the Hong Kong Institution of Engineers, 5(1), 6-13.
  7. Chan, H.C., Pan, A.D.E., Pam, H.J. and Kwan, A.K.H. (1998b), "Seismic detailing of reinforced concrete buildings with relevance to Hong Kong design practice (Part II)", Transactions of the Hong Kong Institution of Engineers, 5(1), 14-20.
  8. Chandler, A.M., Su, R.K.L., Sheikh, N. and Lam, N.T.K. (2000), "Motion induced by distant earthquakes: effect of sediments and reclamation", Proc. Int. Conf. Advances in Structural Dynamics (ASD2000), The Hong Kong Polytechnic University, 1, 185-192.
  9. Chandler, A.M. Su, R.K.L. and Lee, P.K.K. (2002), "Seismic drift assessment for Hong Kong Buildings", Proceedings of the Annual Seminar 2001/02, The Hong Kong Institution of Engineers Structural Division & The Institution of Structural Engineers (HK Division), 17 May 2002, 1-15.
  10. Chopra, A.K. and Goel, R.K. (1999), "Capacity-spectrum-demand methods based on inelastic design spectrum", JU Earthquake Spectra, 15(4), 637-656. https://doi.org/10.1193/1.1586065
  11. Collins, M.P. and Mitchell, D. (1997), Prestressed Concrete Structures, Response Publications, Canada.
  12. GEO (1997), Pilot Study of Effects of Soil Amplification of Seismic Ground Motions in Hong Kong, Technical Note TN 5/97, Geotechnical Engineering Office, Civil Engineering Department, Hong Kong.
  13. ETABS (1997), Three Dimensional Analysis of Building Systems (version 7.12), User's Manual, Computers & Structures Inc.
  14. Idriss, I.M. and Sun, J.I. (1992), User's Manual for SHAKE-91, sponsored by National Institute of Standards and Technology, Maryland, U.S.A. and Department of Civil & Environmental Engineering, University of California, Davis, U.S.A.
  15. Kowalsky, M.J., Priestley, M.J.N. and MacRae, G.A. (1995), "Displacement-based design of RC bridge columns in seismic regions", Earthq. Eng. Struct. Dyn., 24, 1623-1643. https://doi.org/10.1002/eqe.4290241206
  16. Krawinkler, H. and Seneviratna, G.D.P.K. (1998), "Pros and cons of a pushover analysis of seismic performance evaluation", Eng. Struct., 20(4-6), 452-464. https://doi.org/10.1016/S0141-0296(97)00092-8
  17. Lam, N.T.K., Wilson, J.L. and Hutchinson, G.L. (2000a), "Generation of synthetic earthquake accelerograms using seismological modelling: a review", J. Earthquake Engineering, 4(3), 321-354. https://doi.org/10.1142/S1363246900000163
  18. Lam, N.T.K., Wilson, J.L., Chandler, A.M. and Hutchinson, G.L. (2000b), "Response spectral relationships for rock sites derived from the component attenuation model", Earthq. Eng. Struct. Dyn., 29(10), 1457-1490. https://doi.org/10.1002/1096-9845(200010)29:10<1457::AID-EQE969>3.0.CO;2-Q
  19. Lam, N.T.K., Wilson, J.L., Chandler, A.M. and Hutchinson, G.L. (2000c), "Response spectrum modelling for rock sites in low and moderate seismicity regions combining velocity, displacement and acceleration predictions", Earthq. Eng. Struct. Dyn., 29(10), 1491-1526. https://doi.org/10.1002/1096-9845(200010)29:10<1491::AID-EQE970>3.0.CO;2-T
  20. Lam, N.T.K., Wilson, J.L. and Chandler, A.M. (2001), "Seismic displacement response spectrum estimated from the frame analogy soil amplification model", J. Eng. Struct., 23, 1437-1452. https://doi.org/10.1016/S0141-0296(01)00049-9
  21. Lee, P.K.K., Kwan, A.K.H. and Zheng, W. (2000), "Tensile strength and elastic modulus of typical concrete made in Hong Kong", Transactions of Hong Kong Institution of Engineers, 7(2), 35-40.
  22. Mander, J.B., Priestley, M.J.N and Park, R. (1988), "Theoretical stress-strain model for confined concrete", J. Struct. Eng., ASCE, 114(8), 1804-1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804)
  23. Mayes, R. (1995), "Interstory drift design and damage control issues", Journal of the Structural Design of Tall Building, 4, 15-25. https://doi.org/10.1002/tal.4320040104
  24. Mwafy, A.M. and Elnashai, A.S. (2001), "Static pushover versus dynamic collapse analysis of RC buildings", J. Eng. Struct., 23(5), 407-424. https://doi.org/10.1016/S0141-0296(00)00068-7
  25. Newmark, N.M. and Hall, W.J. (1982), Earthquake Spectra and Design, EERI Monograph, Earthquake Engineering Research Institute, California, USA.
  26. Park, R. (1996), "A static force-based procedure for the seismic assessment of existing R/C moment resisting frames", Proc. the 1996 Technical Conference of the New Zealand National Society for Earthquake Engineering, Plymouth, 22-24 March, 54-67.
  27. Paulay, T. and Priestey, M.J.N. (1992), Seismic Design of Reinforced Concrete and Masonry Buildings, John Wiley & Sons, New York.
  28. Priestley, M.J.N. (1996), "Direct displacement seismic assessment of existing reinforced concrete buildings", Bulletin of the New Zealand National Society for Earthquake Engineering., 29(4), 256-272.
  29. Priestley, M.J.N. (1998), "Brief comments on elastic flexibility of reinforced concrete frames and significance of seismic design", Bulletin of the New Zealand National Society for Earthquake Engineering, 31(4), 246-259.
  30. Priestley, M.J.N. and Calvi, G.M. (1997), "Concepts and procedures for direct displacement-based design and assessment", Proc. the Workshop on Seismic Design Approaches for the 21st Century, June 1997, Slovenia.
  31. Priestley, M.J.N. and Kowalsky, M.J. (1998), "Aspects of drift and ductility capacity of rectangular cantilever structural walls", Bulletin of the New Zealand National Society for Earthquake Engineering, 31(2), 73-85.
  32. Priestley, M.J.N. and Kowalsky, M.J. (2000), "Direct displacement-based seismic design of concrete buildings", Bulletin of the New Zealand National Society for Earthquake Engineering, 33(4), 421-444.
  33. Pun, W.K. (1994). "Earthquake resistance of buildings in Hong Kong", Asia Engineer, 25-28.
  34. Scott, D.M., Pappin, J.W. and Kwok, M.K.Y. (1994), "Seismic design of buildings in Hong Kong", Transactions of the Hong Kong Institution of Engineers. 1(2), 37-50.
  35. Sheikh, N. (2001), Simplified Analysis of Earthquake Site Response with Particular Application to Low and Moderate Seismicity Regions, MPhil Thesis, The University of Hong Kong.
  36. Uniform Building Code, UBC (1997), International Conference of Building Officials. Chapter 23, Part 3: Earthquake Design.
  37. Waekava, K. and Xu, A. (2000), "Shear failure and ductility of RC columns after yielding of main reinforcement", Engineering Fracture Mechanics, 65(2-3), Jan., 335-368. https://doi.org/10.1016/S0013-7944(99)00119-8
  38. Watson, S., Zahn, F.A. and Park, R. (1994), "Confining reinforcement for concrete columns", J. Struct. Eng., ASCE, 120(6), 1798-1824. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:6(1798)

Cited by

  1. Multi-hazard performance assessment of a transfer-plate high-rise building vol.6, pp.4, 2007, https://doi.org/10.1007/s11803-007-0780-9
  2. Rapid assessment of seismic demand in existing building structures vol.18, pp.4, 2009, https://doi.org/10.1002/tal.444
  3. Assessment of low-rise building with transfer beam under seismic forces vol.25, pp.12, 2003, https://doi.org/10.1016/S0141-0296(03)00121-4
  4. Experimental and analytical studies on tall buildings with a high-level transfer story vol.16, pp.3, 2007, https://doi.org/10.1002/tal.317
  5. Earthquake-induced shear concentration in shear walls above transfer structures vol.18, pp.6, 2009, https://doi.org/10.1002/tal.458
  6. Analytical modelling of podium interference on tower walls in buildings 2017, https://doi.org/10.1080/13287982.2017.1396870
  7. Earthquake risk assessment of seismically isolated extradosed bridges with lead rubber bearings vol.29, pp.6, 2008, https://doi.org/10.12989/sem.2008.29.6.689
  8. Experimental and Numerical Investigations of Composite Frames with Innovative Composite Transfer Beams vol.143, pp.7, 2017, https://doi.org/10.1061/(ASCE)ST.1943-541X.0001776
  9. Performance-based design in earthquake engineering: a multi-disciplinary review vol.23, pp.12, 2002, https://doi.org/10.1016/s0141-0296(01)00070-0
  10. A simplified design approach for modelling shear force demand on tower walls supported on a transfer structure in regions of lower seismicity vol.15, pp.1, 2002, https://doi.org/10.12989/eas.2018.15.1.097
  11. Experimental and Numerical Studies on Seismic Behavior of Composite Frames with Initial Heavy Load Conditions vol.44, pp.2, 2002, https://doi.org/10.1007/s40996-019-00252-4
  12. Punching Shear Stress in Post-Tensioned Transfer Plate of Multi-Story Buildings vol.10, pp.17, 2002, https://doi.org/10.3390/app10176015
  13. Efficient Strategy for Monitoring Stresses in High-Rise Buildings vol.26, pp.4, 2002, https://doi.org/10.1061/(asce)sc.1943-5576.0000617