초록
중앙부 철골조와 단부 RC조로 이루어진 혼합구조보인 RS 보와 RC 기둥으로 이루어진 접합부의 비탄성 거동 및 내진성능을 구명하기 위하여 반복가력에 의한 접합부 실험을 진행하였다. 본 연구는 RC-RS 접합부의 모멘트비를 변수로 하여 두 개의 내부접합부와 한 개의 외부접합부 등 총 3개의 시험체를 제작하여 실험을 진행하였다. 실험결과, 강도와 연성능력은 충분히 발휘하였으나, 접합부의 강성은 부족한 결과를 나타내었다. 이는 RS 보를 구성하는 철골보와 RC 보를 연결하는 강재매입구간에서의 철골 보의 미끄러짐에 의한 변위의 증가로 인하여 강성의 저하가 발생한 것으로 판단된다. 또한 Hawkins의 제안안에 의한RC-RS 접합부의 내진성능을 평가해 본 결과, 접합부의 초기강성의 부족으로 부재각 0.5 %에서의 공칭강도의 발현은 만족하지 못하였으나, 그외의 내진성능 평가지표인 강도유지능력, 상대 에너지소산비 및 종국후 초기강성비나 초기강도비 등의 측면에서는 우수한 능력을 발휘하였다. 따라서 구조물에서 RC-RS 접합부를 적용할 경우, RC 코어 월과 같은 초기 횡 강성을 보완할 수 있는 적절한 구조시스템과 병행하여 적용하면 강진지역의 구조물에도 충분히 적용이 가능하다고 판단된다.
An experimental study was carried out for beam-column joints composed of RC column and RS beams. The purpose of this study is to examine the inelastic seismic behavior for the RC-RS connection. Two interior and one exterior beam-column assemblies with variable moment ratios were tested. Experimental results showed that strength and deformability except stiffness were satisfactory. It is considered that the lack of stiffness was due to the slipping of steel beam from RS beam. The behavioral characteristics of the RC-RS connection were evaluated according to the quideline suggested by Hawkins et al. Nominal strength at 5 % joint distortion was not satisfactory, but all the other requirements, such as strength preserving capability, energy dissipation, and initial stiffness and strength ratios after peak load were satisfactory compared with the guideline. Thus it was concluded that the RC-RS connections can maintain ductility with excellent energy-dissipating capacity if being provided with appropriate reinforced structural system such as RC core wall for the initial lateral stiffness.