한국군사과학기술학회지 (Journal of the Korea Institute of Military Science and Technology)

  • 제5권2호
  • /
  • Pages.116-122
  • /
  • 2002
  • /
  • 1598-9127(pISSN)
  • /
  • 2636-0640(eISSN)
한국군사과학기술학회 (The Korea Institute of Military Science and Technology)
권호 표지

전자파환경에서 EED에 유기되는 전류에 관한 연구

A Study on the induced Current of Electro Explosive Device Bridge Wire under Electromagnetic Field

  • 발행 : 2002.07.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

Electro Explosive Devices can be susceptible to electromagnetic interference. When these components are exposed to external electromagnetic fields, it may cause to induce sufficient current to generate enough heat for an inadvertent detonation. It is almost impossible to monitor the event of firing throughout the electromagnetic environment test. The survivability of EED for hazards of electromagnetic radiation is investigated. A fiber optic sensor is installed near the bridge wire after removing explosive material in order to measure the induced current on the bridge wire. The length of lead-wire of the EED fabricated is around 15 cm.

키워드

참고문헌

  1. Emil J. Eichblatt, Jr., Test and Evaluation of the Tactical Missile, American Institute of Aeronautics and Astronautics, Inc. pp.311-312, 1989
  2. Y.T.Lo, S.W.Lee, Antenna Handbook, volume II, pp.6-2-6-23, VAN NOST- RAND REINHOLD
  3. David A Weston, Electromagnetic Com-patibility Principles and Applications, Marcel Dekker, Inc., pp.56-66, 1991
  4. David Morgan, A Handbook for EMC Testing and Measurement, Peter Pere-grinus Ltd., pp.72-84, 1994
  5. Y.T.Lo, S.W.Lee, Antenna Handbook, pp.3-13-3-16, VAN NOSTRAND REIN- HOLD
  6. Thomas A. Milligan, Modern Antenna Design, McGraw-Hill Book Company, pp.66-72
  7. Gordon L. Mitchell, 'Gigahertz RMS Current Sensors for EMC Testing', Fiber Optic and Laser Sensors, SPIE Vol. 1367. 1990
  8. W.N.MacPherson, 'Phase Demodulation in Optical Fibre Fabry-Perot Sensors with Inexct Phase Steps', IEE Proc. Opto-electron., Vol.144, No.3, June 1997
  9. Preclusion of Ordnance Hazards in Elec-tromagnetic Fields ; General Requirements for, MIL-STD-1385B