한국농공학회지 (Magazine of the Korean Society of Agricultural Engineers)

한국농공학회 (The Korean Society of Agricultural Engineers)
권호 표지

Load-Carrying Capacity Assessment of Deteriorated Rural Bridge

  • Kim, Han-Joong (Formerly Post Doctoral Researcher in University of Colorado) ;
  • Kim, Jong-Ok (Department of Bio-Industrial Engineering, Kongju National University) ;
  • Yang, Seung-Ie (Post Doctoral Researcher in University of Colorado)
  • 발행 : 2002.12.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

Most of rural bridges have passed 30 years of age since they were built, which have to support unexpected overload caused by changed design load and excessive amount of transportation. For these rural bridges, repairs and replacements are needed. Even though there have been attempt to estimate the safety of existing bridges deteriorated with major defects, those approaches must rely on the observable damage and subsequent decisions are made subjectively. To avoid the high cost of rehabilitation, the bridge rating must correctly represent the present load-carrying capacity. Rating engineers use a methods such as Allowable Stress Design (ASD), Load Factor Design (LFD), and Load Resistance Factor Design (LRFD) to evaluate the bridge load carrying capacity. In this paper, the load rating methods are introduced, and it is illustrated how to use the load test data from literature survey. Load test is conducted to the bridge that was built 30 years ago in rural area. From load test results, new maintenance method is suggested instead of the bridge replacement.

키워드

참고문헌

  1. Ahmed, Farhana, 2000, Use of load tests in rating highway bridges, M.S. Thesis of Univ. of Colorado
  2. American Association of State Highway Transportation Officials, 1983, Manual for maintenance inspection of bridges : 53
  3. American Association of State Highway Transportation Officials, 1992, Standard specification for highway bridges : 686
  4. American Association of State Highway Transportation Officials, 1994, Manual for condition evaluation of bridges : 136
  5. Baker, Michael G., 2001, Quantifying field-test behavior for rating steel girder bridges, Journal of Bridge Engineering, ASCE Vol. 6, No.4 : 254-261
  6. Beal, D. B., and Loftus, M. J. 1988, Load tests on five bridges, Engineering Research and Development Bureau, New York State Department of Transportation : 19
  7. Chajes, M. J., Mertz, D. R. and Commander, B., 1997, Experimental load rating of a posted bridge, Journal of Bridge Engineering, ASCE Vol 2, No 1 : 1-10
  8. Faber, Michael H., Val, Dimitri V. and Stewart, Mark G., 2000, Proof load testing for bridge assessment and upgrading, Engineering Structure, ELSEVIER, Vol. 22: 1677-1689
  9. Fu, G., Pezze, F. P. and Alampalli, S., 1997, Diagnostic load testing for bridge load rating, Transportation Research Record, No. 1594 : 125-133
  10. Ghosn, M., Moses, F. and Gobieski, J., 1986, Evaluation of steel bridges using in-service testing, Transportation Research Record 1072, TRB, Washington, DC : 71-78
  11. Jauregui, D. V., Yura, J. A., Frank, K. H. and wood, S. L., 2002, Field evaluation of decommisioned noncomposite steel girder bridge, Journal of Bridge Engineering, ASCE. Vol. 7, No.1 : 39-49
  12. Kim, J. O., 2000, Development of system for optimum design, safety appraisal and repair works on agricultural structures, Research Report, Seoul, Ministry of Agriculture and Forestry (in Korean)
  13. Kissane, R. J., Beal, D. B. and Sanford, J. A., 1980, Load rating of short-span highway bridges, FHWA/NY/RR-80/79, New York State Department of Transportation: 35
  14. Ministry of Construction and Transportation, 1993, Standard specification for road bridges.(in Korean)
  15. Moses, F., Ghosn, M. and Gobieski, J., 1985, Weigh-in-motion applied to bridge evaluation, FHWA/OH-85/012, Case Western Reserve University : 168
  16. Yoo, C. H. and Stallings, J. M., 1993, Bridge testing, Alabama Department of Transportation, Auburn University : 85