Prediction of Dimensional Instability Resulting from Layer Removal of an Internally Stressed Orthotropic Composite Cylinder

  • Shin, Shang-Hyon (Department of Marine Engineering, Mokpo Maritime University)
  • Published : 2002.05.01

Abstract

When a layer of cylindrical composite component containing an axisymmetric residual stress state is removed from the inner or outer surface, the dimension of the remaining material changes to balance internal forces. Therefore, in order to machine cylindrical composite components within tolerances, it is important to know dimensional changes caused by residual stress redistribution in the body. In this study, analytical solutions for dimensional changes and the redistribution of residual stresses due to the layer removal from a residually stressed cylindrically orthotropic cylinder were developed. The cylinder was assumed to have axisymmetric radial, tangential and axial residual stresses. The result of this study is useful in cases where the initial residual stress distribution in the component has been measured by a non-destructive technique such as neutron diffraction with no information on the effect of layer removal operation on the dimensional changes.

Keywords

References

  1. Barrera, E.V. and Tello, H., 1993, 'Nondestructive Determination of Residual Stresses by Neutron Diffraction,' Symposium on Residual Stresses in Composites, Denver, The minerals, Metals & Materials Society, pp. 95-113
  2. Boo, M.H., Park, Y.C. and Hirose, Y., 1998, 'Tri-axial Stress Analysis of Composite Materials for X-ray Stress Measurement,' J. KSME, Vol. 23, No. 7, pp. 1173-1181
  3. Fujiwara, H., Hanabusa, T. and Nakao, I., 1988, 'Redistribution of Residual Stresses and Dimensional Change,' International Conference on Residual Stresses, ICRS2, Nancy, Elsevier Applied Science
  4. Honda, K., Toril, T. and Fei, Z., 1988, 'Analysis and Measurements of Residual Stress Redistribution due to Material Removal in a Plate,' J. Soc. Mat. Sci. Japan, Vol. 37, No. 415, pp. 391-398 https://doi.org/10.2472/jsms.37.391
  5. Joo, J. W. and Park, C. K., 1998, 'Determination of Non-uniform Residual Stress by the Hole Drilling Method,' J. KSME, Vol. 22, No. 2, pp. 268-277
  6. Lekhnitskii, S. G., Tsai, S. W., Cheron, T., 1968, 'Anisotropic plate,' Gordon and Breach Science Pub
  7. Olson, W. A. and Bert, C. W., 1966, 'Analysis of Residual Stresses in Bars and Tubes of Cylindrically Orthotropic Materials,' Experimental Mechanics, pp. 451-457 https://doi.org/10.1007/BF02326558
  8. Voyiadjis, G. Z. and Hartley, C. S., 1987, 'Residual-Stress Determination of Concentric Layers of Cylindrically Orthotropic Materials,' Experimental Mechanics, pp. 290-297 https://doi.org/10.1007/BF02318095
  9. Voyiadjis, G. Z., Kiousis, P. D. and Hartley, C. S., 1985, 'Analysis of Residual Stresses in Cylindrically Anisotropic Materials,' Experimental Mechanics, pp. 145-147 https://doi.org/10.1007/BF02328804