Abstract
Dry etching of copper film using $O_2$ plasma and H(hfac) has been investigated. A one-step process consisting of copper film oxidation with an $O_2$ plasma and the removal of surface copper oxide by the reaction with H(hfac) to form volatile Cu(hfac)$_2$ and $H_2O$ was carried but. The etching rate of Cu in the range from 50 to 700 /min was obtained depending on the substrate temperature, the H(hfac)/O$_2$ flow rate ratio, and the plasma power. The copper film etch rate increased with increasing RF power at the temperatures higher than 215$^{\circ}C$. The optimum H(hfac)/O$_2$ flow rate ratio was 1:1, suggesting that the oxidation process and the reaction with H(hfac) should be in balance. Cu patterning using a Ti mask was performed at a flow rate ratio of 1:1 on 25$0^{\circ}C$\ulcorner and an isotropic etching profile with a taper slope of 30$^{\circ}$was obtained. Cu dry patterning with a tapered angle which is necessary for the advanced high resolution large area thin film transistor liquid-crystal displays was thus successfully obtained from one step process by manipulating the substrate temperature, RF power, and flow rate ratio.
O$_2$plasma와 H(hfac)을 이용한 Cu 박막의 건식 식각을 조사하였다. 휘발성이 큰 Cu(hfac)$_2$와 $H_2O$를 탈착시키기 위하여 $O_2$ Plasma를 이용한 Cu 박막의 산화와 생성된 Cu 산화막을 H(hfac)과의 반응으로 제거하는 공정으로 식각을 수행하였다. Cu 박막의 식각율은 50-700 /min의 범위를 보였으며, 기판온도, H(hfac)/O$_2$ 유량비, plasma power에 따라 변하였다. Cu 박막의 식각율은 기판온도 215$^{\circ}C$보다 높은 온도구간에서 RF power가 증가함에 따라 증가하였고, 산화 공정과 H (hfac)과의 반응이 균형을 이루는 최적의 H (hfac)/O$_2$ 유량비는 1:1임을 확인하였다. Ti mask를 사용한 Cu Patterning은 유량비 1 : 1, 기판온도 25$0^{\circ}C$에서 실시하였고, 30$^{\circ}$외 taper slope를 갖는 등방성 etching profile을 얻을 수 있었다. Taper angle을 갖는 Cu 건식 patterning은 고해상도의 대면적 thin film transistor liquid-crystal(TFT-LCDs)를 위래 필요한 것으로써 기판온도, RF power, 유량비를 조절한 one-step 공정으로부터 성공적으로 얻을 수 있었다.