The Uplift Capacity of Plane and Corrugated Piles for Pipe Frame Greenhouse

파이프 골조온실의 민말뚝과 주름말뚝의 인발저항력

The uplift capacity of a pile for improving the wind resistance of the 1-2 W type plastic film pipe on greenhouses was tested using the plane and corrugated piles with various shapes and diameters. First, the resistant uplift capacity was measured by using the uplift loading on plane piles. As the uplift loading on plane piles increased, the resistant uplift capacity also increased until the loading was reached to ultimate uplift capacity. After ultimate uplift capacity was appeared the uplift displacement, the uplift capacity was decreased gradually. Secondly, the resistant uplift capacity was measured by using the uplift loading on corrugated piles. After the uplift capacity was reached the uplift displacement, the uplift capacity was continually increased or decreased. In general, the ultimate uplift capacity was independent of pile shapes, pile diameter length, and embedded pipe depth. However, the ultimate uplift capacity of a corrugated pile was twice more than that of a plane pile without regard to its diameter and embedded depth. The ultimate uplift capacity per unit pile area was increasing in deeper embedded depth. However, the longer a pile diameter was, the less ultimate uplift capacity. The uplift capacity of a plane pile, used in conjunction with the design wind velocity (26.9m.s$^{-1}$ ) of the project area, was unsatisfiable without regard to diameters and embedded depths of piles, while most of corrugated piles were well appeared uplift capacity under various experimental conditions.

본 연구에서는 1-2W형 플라스틱피복 파이프 온실의 내풍성을 증대시키기 위하여 형상 및 직경이 서로 다른 말뚝에 대하여 인발저항력을 검토하였다. 그 결과 민말뚝의 경우, 인발하중이 증가함에 따라 인발저항력은 증가하지만, 대부분의 경우 인발변위가 발생한 직후의 하중단계에서 극한인발저항력에 도달하였다. 그러나 주름말뚝의 경우는 인발변위가 발생한 이후에도 실험을 종료할 때까지 인발저항력의 증감이 반복되는 경향을 나타내었다. 그리고 기초의 형상, 직경 및 매입깊이에 따라 극한인발저항력은 다르지만, 본 실험의 경우 직경과 매입깊이에 관계없이 극한인발저항력은 주름말뚝이 민말뚝보다 약 2배 정도 크게 나타났다. 단위면적당 극한인발저항력은 매입깊이가 깊어질수록 증가하지만, 직경이 커지면 감소하였다. 실험 대상지역의 설계풍속(26.9m.s$^{-1}$)을 고려하면, 민말뚝은 매입깊이에 관계없이 기초의 인발저항력이 부족하였고, 주름말뚝의 경우은 대부분의 실험조건에서 충분한 것으로 나타났다.