A New Liquid Crystal Color Calibration Technique Using Neural Networks and Median Filtering

  • 발행 : 2000.01.01

초록

This study has developed a new liquid crystal calibration technique using Neural networks with median filtering and applied this technique to heat transfer measurements. To verify the validity of this new measurement technique, the local Nusselt numbers on a flat plate surface subjected to an axisymmetric impinging jet were measured and compared with the results by the conventional Hue-temperature calibration technique under the same conditions. Because the Neural networks predict the non-linear relations between temperatures and corresponding R, G, B values, Neural networks-median filtering calibration technique can utilize a much wider color band in the experiment than the Hue-temperature calibration technique, resulting in a significant reduction in the experimental time.

키워드

참고문헌

  1. Baughn, J. W., and Shimizu, S., 1989, 'Heat Transfer Measurement From as Surface With Uniform Heat Flux and an Impinging Jet,' ASME Journal of Heat Transfer, Vol. 111, pp. 1096-1098
  2. Baughn, J. W., Ireland, P. T., Jones, T. V., and Saniei, N., 1989b, 'A Comparison of the Transient and Heated-Coating Methods for the Measurements of the Local Heat Transfer Coefficients on a Pin Fin,' ASME Journal of Heat Transfer, Vol. 111, pp. 877-881
  3. Camci, C., Kim, K., Hippensteele, S. A., and Poinsatte, P. E., 1991, 'Convection Heat Transfer at the Curved Bottom Surface of a Square to Rectangular Transition Duct Using a New Hue Capturing Based Liquid Crystal Technique,' Fundamental Experimental Measurements in Heat Transfer, ASME HTD-Vol. 179
  4. Cooper, T. E., Field, R. J., and Meyer, J. F., 1975, 'Liquid Crystal Thermography and Its Application to the Study of Convective Heat Transfer,' ASME Journal of Heat Transfer, Vol. 97, pp. 1857-1868
  5. Fergason, J. L., 1964, 'Liquid Crystal,' Scientific American, Vol. 222, pp. 76-85
  6. Goldstein, R. J., and Timmers, J. F., 1982, 'Visualization of Heat Transfer from Arrays of Impinging Jets,' International Journal of Heat and Mass Transfer, Vol. 25, pp. 1857-1868
  7. Ireland, P. T., and Jones, T. V., 1985, 'The Measurement of Local Heat Transfer Coefficients in Blade Cooling Geometries,' AGARD Conference Proceedings No. 390, Paper 28
  8. Jones T. V., 1977, 'Heat Transfer, Skin Friction, Total Temperature and Concentration Measurements,' Measurements of Unsteady Fluid Dynamic Phenomena, Richards B. E., ed., McGraw Hill, pp. 63-102
  9. Jones, T. V., and Hippensteele, S. A., 1987, 'High-Resolution Heat-Transfer Coefficient Maps Applicable to Compound Curve Surfaces Using Liquid Crystals in a Transient Wind Tunnel,' Development in Experimental Technique in Heat Transfer and Combustion, ASME HTD -71
  10. Kline, S. J., and McKlintock, F. A., 1953, 'Describing Uncertainties in Single Sample Experiments,' Mechanical Engineering, Vol. 75, pp. 3-8
  11. Lee, S. J., Lee, J. H., and Lee, D. H., 1994, 'Heat Transfer Measurement Using Liquid Crystal with an Elliptic Jet Impinging upon the Flat Surface,' International Journal of Heat and Mass Transfer, Vol. 37, pp. 967-976
  12. Lee, D. H., and Greif, R., Lee, S. J., and Lee, J. H., 1995, 'Heat Transfer from a Surface to a Fully Developed Axisymmetric Impinging Jet,' ASME Journal of Heat Transfer, Vol. 117, pp. 772-776
  13. Lee, D. H., Chung, Y. S., and Kim, D. S., 1997, 'Turbulent Flow and Heat Transfer Measurements on a Curved Surface with a Fully Developed Round Impinging Jet,' International Journal of Heat and Flow, Vol. 18 No.1, pp. 160 -169 https://doi.org/10.1016/S0142-727X(96)00136-1
  14. Schultz, D. L., and Jones, T. V., 1973, 'Heat Transfer Measurements in Short Duration Hypersonic Facilities,' Agardograph No. 165