Flow Characteristics inside a Throttle Valve Used to Control the Intake Air Flow in Engines

엔진의 흡기 공기량 조절용 스로틀 밸브에서의 유동 특성

  • 김성초 (순천대학교 기계공학과) ;
  • 김철 (순천제일대학 차량기계과)
  • Published : 1999.11.01

Abstract

This paper describes the air flow characteristics inside the throttle valve. Tow-dimensional steady incompressible Navier-Strokes equation are solved numerically with embedding the conceopt of the artificial compressibility and adopting the Baldwin-Lomax turbulence model. With varying the valve opening angles(the Reynolds number )such as 15$^{\circ}$(5000) , 45$^{\circ}$(3000) , 75$^{\circ}$(7000) and 90$^{\circ}$(10000), respectively. tow cases, with a valve shaft and without one, are analysed. The pressure loss between the entrance and exit is severe at 15$^{\circ}$, 100 times as larger as that of 90$^{\circ}$ case, which also depends much on the existece of the valve shaft. The counter rotating vortices are formed over the valve plate with the shaft at only 75$^{\circ}$. They are smally and very large scale in front and back of the valve shaft , respectively. The velocity profiles of 15$^{\circ}$ and 90$^{\circ}$ at the exit are almost symmetric to the horizontal center line, however, the symmetricity is no longer maintained at 45$^{\circ}$ and 75$^{\circ}$ , and in addition, the flow at 75$^{\circ}$ is enforced a lot below center line. The pressure distribution on the walls is largely changed near the valve shaft, and its magnitude becomes great as the valve angle decreases.

Keywords

References

  1. Trans. of ASME, J. of Eng. for gas Turbine and Power v.112 Valve Event Optimization in a Sparc-Ignition Engine D. N. Assanis;M. Polishak
  2. JSAE Review v.12 no.1 Analysis of Gas Flow in the Intake Manifold of Gasoline Engines M. Fusieda;Y. Ohyama;M. Ooshuga;T. Nogi
  3. 한국자동차학회논문집 v.2 no.5 헤드형상에 따른 2행정기관 실린더 내의 유동장에 대한 수치해석적 연구 강동원;양희천;채수;유홍선
  4. 한국자동차공학회 추계학술대회 논문집 점화기관에서 스파크 프러그형 광섬유 프로브와 PCB 헤드가 스켓형 이온 프로브를 이용한 엔진 유동 형태에 따른 화염 전파 특성 박덕규;이경환
  5. SAE Tech. Paper 950678 Analysis of Fuel Behavior in the Spark-Ignition Engine Start-Up Process M. J. Sampson;J. B. Heywood
  6. 한국자동차공학회논문집 v.4 no.1 흡기관 내의 혼합기 유동 특성에 관한 연구 이창식;조병옥
  7. 한국자동차공학회지 v.20 no.3 직접 분사 가솔린 엔진의 개발 조진호
  8. 한국자동차공학회논문집 v.6 no.5 배출물 저감을 위한 촉매변환기 내의 3차원 유동 해석 정수진;김우승
  9. Proc. of the 23rd FISITA Conf. v.Ⅰ Practical Measuring Method of Deposited Fuel and Evaporated Fuel in the Induction System H. Monden;R. Kataoka
  10. Internal Combustion Engine Fundamentals J. B. Heywood
  11. J. of Comp. Physics v.2 A Numerical Method for Solving Incompressible Viscous Flow Problems Chorin, A.J.
  12. AIAA Paper 84-0252 On the method of Pseudo Compressibility for Numerically Solving Incompressible Flows J. L. C. Chang;D. Kwak
  13. 한국항공우주학회지 v.23 no.5 원통과 사각통을 결합한 도관내의 공기 흐름 해석 윤용현
  14. 한국항공우주학회지 v.24 no.1 원형 단면에서 사각 단면으로 바뀌는 도관내 공기흐름의 수치적 해석 윤용현;김성초
  15. AIAA Paper 78-0257 Thin Layer Approximation and Algebraic Model for Separated Turblence Flows B. S. Baldwin;H. Lomax