노즐 형상 및 입경에 따른 난류 분류중의 미립자 유동 특성에 관한 연구

A Study of Particle Motion for Nozzle Geometry and Particle Diameter in Turbulent Jet Flow

  • 김종철 (국민대학교 기계공학과 대학원) ;
  • 황승식 (국민대학교 기계공학과 대학원) ;
  • 전운학 (국민대학교 기계공학과)
  • 발행 : 1999.08.01

초록

This paper is a review of the results of examining the flow characteristics of gas and particles with regards to pipe-type nozzle and converging nozzles depending on nozzle geometry. The nozzles used in this experiment are the pipe-type nozzle which can sufficiently mix the gas and particles, and the converging nozzle which can rapidly accelerate fluid . The particles used at the time of this experiment each measured 0.8, 30, 60 and 80${\mu}{\textrm}{m}$ in the diameter. The Phase Doppler Particle Analyzer was used to measure the velocity of each particle, and the Hot-wire probe was used to measure the spectrum in order to analyze the flow near the nozzle exit of the 0.8${\mu}{\textrm}{m}$ particle.

키워드

참고문헌

  1. 日本機械學會論文集 v.60 no.575 B 格子亂流場における粒子擴散現象 Ishima(外 2名)
  2. Int. J. Multiphase Flow v.20 J. B. Mclaughin
  3. The 2nd Int. Conf. on Multiphase Flow R. J. Perkins
  4. ASME v.114 N. Hata
  5. J. AIAA v.22 D. Modarres(et al.)
  6. 한국자동차공학회논문집 v.6 no.5 입자크기와 노즐형상이 입자유동특성에 미치는 영향 전운학;김종철;황승식
  7. Appl.Sci.Res. v.16 Hjelmtelt. A.Jr;Mockros.L.F.
  8. J. O. Tchen
  9. KEPCO, Job Number 2954 System Manual Real-Time Signal Analyzer Aerometrics, Inc