초록
n-InP(001)기판과 PECVD법으로 ${Si}_3N_4$(200nm)막이 성장된 InP 기판사이의 direct wafer bonding을 분석하였다. 두 기판을 접촉시켰을 때 이들 사이의 결합력에 크게 영향을 주는 표면 상태를 접촉각 측정과 AFM을 통해서 분석하였다. InP 기판은 $50{\%}$ 불산용액으로 에칭하였을 때 접촉각이 $5^{\circ}$, RMS roughness는 $1.54{\AA}$이었다. ${Si}_3N_4$는 암모니아수 용액으로 에칭하였을 때 RMS roughness가 $3.11{\AA}$이었다. Inp 기판과 ${Si}_3N_4$/InP를 각각 $50{\%}$ 불산 용액과 암모니아수 용액에 에칭한 후 접촉시켰을 때 상당한 크기의 초기 겹합력을 관찰할 수 있었다. 기계적으로 결합된 시편을 $580^{\circ}C$-$680^{\circ}C$, 1시간동안 수소 분위기와 질소분우기에서 열처리하였다. SAT(Scanning Acoustic Tomography)측정으로 두 기판 사이의 결합여부를 확인하였다. shear force로 측정한 InP 기판과 ${Si}_3N_4$/InP사이의 결합력은 ${Si}_3N_4$/InP 계면의 결합력만큼 증가되었다. TEM과 AES를 이용해서 di-rect water bonding 계면과 PECVD계면을 분석하였다.
The direct wafer bonding between n-InP(001) wafer and the ${Si}_3N_4$(200 nm) film grown on the InP wafer by PECVD method was investigated. The surface states of InP wafer and ${Si}_3N_4$/InP which strongly depend upon the direct wafer bonding strength between them when they are brought into contact, were characterized by the contact angle measurement technique and atomic force microscopy. When InP wafer was etched by $50{\%}$ HF, contact angle was $5^{\circ}$ and RMS roughness was $1.54{\AA}$. When ${Si}_3N_4$ was etched by ammonia solution, RMS roughness was $3.11{\AA}$. The considerable amount of initial bonding strength between InP wafer and ${Si}_3N_4$/InP was observed when the two wafer was contacted after the etching process by $50{\%}$ HF and ammonia solution respectively. The bonded specimen was heat treated in $H^2$ or $N^2$, ambient at the temperature of $580^{\circ}C$-$680^{\circ}C$ for lhr. The bonding state was confirmed by SAT(Scannig Acoustic Tomography). The bonding strength was measured by shear force measurement of ${Si}_3N_4$/InP to InP wafer increased up to the same level of PECVD interface. The direct wafer bonding interface and ${Si}_3N_4$/InP PECVD interface were chracterized by TEM and AES.