초록
일반적으로 발진기 설계에서 출력에 가장 큰 영향을 미치는 부분이 출력단 정합부분인데 기존의 출력단 정합 방법은 스미스차트의 무한대 임피던스 근방에서 정합회로를 설계해야 하므로 최적의 출력 정합회로를 구현해 주기가 어렵다. 본 논문에서는 초고주파 발진기를 설계하는데 있어서 보다 쉽게 최대 발진출력을 얻기 위한 출력단 정합방법에 관하여 연구하였다. 출력단이 정합되지 않은 발진기에 3-dB Coupler Tuner를 연결하고 발진기가 동작하고 있는 상태에서 Tuner 의 가변 단락회로를 조정하여 최대출력이 나오는 지점을 확인하고, Tuner의 S 파라미터를 측정한 후 이를 마이 크로스트립으로 구현하는 벙법을 이용하여 최대 발진출력이 나오는 발진기를 쉽게 설계 제작할 수 있었다. 본 논문에서 제안한 방법으로 설계 제작한 발진기 출력과 기존 정합방법에 의한 발진기 출력을 비교해 보면, 기존의 정합방법에 의한 발진기 출력은 발진주파수 1.0338 GHz에서 6.45 dBm을 나타내었고, 본 논문에서 제시 한 방법으로 제작된 발진기의 출력은 9.71 dBm으로 기존의 정합방법에 의한 발진기 출력보다 3.26 dBm 높은 출력을 나타내었다.
Generally, the output matching circuit has the most influence to the output power of oscillator and existing method for output matching has difficulty for making the optimum output matching circuit because the matching has to be done nearby the infinite impedance area of the Smith Chart. In this paper, it is studied for the output matching circuit of the microwave oscillator to get the maximum output power. The maximum output point can be found by adjusting the position of moving short in the Tuner while the oscillator is operating after connect the 3-dB coupler Tuner to the oscillator without output matching circuit. To design the oscillator for the maximum output power can be done easily with the microstrip line which is realized from the measured S-parameters of Tuner. In compare the oscillator by the existing method with another one by the suggested method in this paper, the first one has 6.45 dBm output power and second one has 9.71 dBm which is 3.26 dBm higher than the first one at the oscillation frequency 1.0338 GHz.