A study on the cutting characteristics of SUS304 by flank wear

Flank 마모에 의한 SUS304의 절삭특성에 관한 연구

  • Yu, Ki-Hyun ;
  • Cheong, Chin-Yong ;
  • Seo, Nam-Seob
  • 유기현 (전북대학교 기계과 대학원) ;
  • 정진용 (전북대학교 기계과 대학원) ;
  • 서남섭 (전북대학교 기계과)
  • Published : 1994.04.01

Abstract

This expermintal study is intended to investigate he development of flank wear in turning os SUS304 which is used in industrial applications and is acknowledged as a machining difficult material. In cutting process, change of velocity, change of feed, and change of depth of cut were investigated about the effect of flank wear, and slenderness ratio is also investigated. The variations of unit cutting force with the change of rake angle and the change of uncut chip area are observed. The friction angles are calculated for the change friction force and observed. The friction angles are calculated for the change friction force and normal forcd on the different rake angles. From this experimental study, the following results can be said. 1. Under the high cutting speed condition, the flaank wear is affected by the feed and depth of cut, but the influence of feed and depth of cut to the flank wear is reduced when the velocity is low. 2. The smaller slenderness ratio is, the shorter the tool life results in high cutting speed, and the lower cutting speed is, the lower the effect of slenderness ratio to the flank wear is. 3. Using the characteristics of force-RMS, the flank wear of a tool can be detected. There are almost no differences between the RMS characteristics of cutting force and feed force.

Keywords