전단벽 구조물의 모멘트 저항능력에 관한 비탄성 해석모델개발

Development of Analytical Model to Predict the Inelastic Moment Capacity of Reinforced Concrete and Masonry Shear Wall

큰 수평하중을 견딜 수 구조물의 해석 및 설계는 구조물의 거동에 대한 완전한 이해에 바탕을 두는 설계기법의 측면에서 이루어져야 한다. 본 연구는 일반적인 구조물, 특히 콘크리트 전단벽 구조물의 설계와 해석에 적용될 수 있으며, 실험에 의해 그 정도가 확인되는 수치적 해석 모형을 개발하는데 있다. 즉 설계방법을 이해하고 개선하므로써 구조물의 안전성을 보장해 줄 수 있는 해석모형을 제시하는 것이 본연구의 기본 목적이다. 이상적으로 이러한 안전성을 모형내에 확보하기 위해서 구조물의 연성거동을 확인할 수 있도록 하였으며 면내하중을 받는 전단벽에 대해 다수의 실험을 통해, 개발된 해석모형의 정확도를 입증하였다. 최종적으로 실험검증을 통한 해석모형을 콘크리트조적도 전단벽의 거동을 잘 예측하였으며, 또한 실무에 관련된 설계화 해석에 응용될 수 있도록 시도되어 그 설계예와 함께 수치적 해석모형의 실용성을 보였다.

A rapid progress has been made over last decade in the state-of-the-art earthquake structura1 engineering towards a better understanding of both the earthqauke ground motion and structural response. These efforts seek to ensure that there will be no serious injury or loss of life in the event of earthquake, and that structures can be built at minimum cost. The design of structures in general, concrete structures in particular, to resist strong ground input motions is not a simple matter, and analytical models for such structures must be developed from a design perspective that accounts for the complexities of the structural responses. The primary obj ective of earthquake structural engineering research is to ensure the safety of structures by understanding and improving a design methodology. Ideally, this would require the development of an analytical model related to a design methodology that ensures a ductile performance. For the accurate assessment of the adequacy of analytically developed model, experiments conducted to study the inplane inelastic cyclic behavior of structures should verify the analytical approach. The fundamental goal of this paper is to present and demonstrate experimentally verified analytical methods that provide the adequate degree of safety and confidience in the behavior of reinforced concrete structural components. This study further attempts to extend the developed modeling techruque for use by practicing structural engineers for both the analysis and design.Plication of the relaxed diaphragm through left thoracotomy was done and result was excellent as seen on Fig. 5. Cause of eventration of the left hemidiaphragm was due to paralysis of the left phrenic nerve which was tested during thoracotomy.