The korean journal of orthodontics (대한치과교정학회지)
- Volume 21 Issue 3
- /
- Pages.543-560
- /
- 1991
- /
- 2234-7518(pISSN)
- /
- 2005-372X(eISSN)
COMPARISON OF THE FRICTIONAL RESISTANCE BETWEEN ORTHODONTIC BRACKET & ARCHWIRE
교정용 BRACKET과 ARCHWIRE 사이의 마찰저항에 대한 비교연구
- Sung, Hyun Mee (Department of Orthodontics, College of Dentistry, Yonsei University) ;
-
Park, Young Chel
(Department of Orthodontics, College of Dentistry, Yonsei University)
- Published : 1991.11.30
Abstract
Practitioners are aware of the presence of friction between bracket system and archwire during sliding movement of teeth. Clinically a mesiodistally applied force must exceed the frictional force to produce a tooth movement. The objective of this study were to determine, on a dry condition, changes in magnitude of friction with respect to load, 3rd order inclination (Torque), archwire materials and ligature type. Three wire alloys (Stainless Steel, TMA, NiTi) in two wire sizes (.016, .016x, .022 inch) were examined respect to two bracket system (Straight, Standard), and two ligature type (Metal, Plastic ligature) at three levels of load (100g, 150g, 200g). The results were as follows; 1. Frictional resistance was found to increase with increasing load for S.S., TMA, NiTi. 2. The straight bracket system was exhibited more frictional force than standard bracket system for .016x, .022 S.S. tightly ligated metal ligature. But, torque difference did not increase friction for loose metal ligature & plastic ligature. 3. Regardless of the ligature type, torque and load, stainless steel wire sliding against stainless steel exhibited the lowest friction, and TMA sliding against stainless steel exhibited the highest friction. 4. The loose stainless steel ligature generated lower frictional resistance than plastic ligature in all experimental groups. 5. The following factors affected friction in decreasing order; wire material ligature type, and load.
Keywords