Proceeding of EDISON Challenge (EDISON SW 활용 경진대회 논문집)
- 2015.03a
- /
- Pages.428-441
- /
- 2015
Modeling of selfie stick using FreeCAD
FreeCAD를 이용한 셀카봉 모델링
- Sung, Gwangwon (Dept. of Mechanical Engineering) ;
- Kim, Youngki (Dept. of Ocean System Engineering, KAIST)
- Published : 2015.03.19
Abstract
Corresponding to the high consumption rate of the selfie stick for cell phone camera, the design of the product is becoming diverse. However, relatively low cost selfie stick models are not strong enough to stand the weight of the cell phone. This results into a bending of the stick or the accidental fall of the cell phone by the failure of the holding unit. As a solution to the problem, design of selfie stick that is structurally strong enough to stand the weight of the cell phone with the minimum weight for the portability is proposed in this paper.