5J32 알루미늄 합금의 마찰 점용접

Spot Friction Welding of 5J32 Al alloy

  • 이원배 (성균관 대학교 신소재 공학과) ;
  • 이창용 (성균관 대학교 신소재 공학과) ;
  • 연윤모 (수원 과학대 자동화 시스템과) ;
  • 정승부 (성균관 대학교 신소재 공학과)
  • 발행 : 2005.11.17

초록

Joint strength of spot friction welded 5J32 Al alloy were investigated according to the tool shape and the tool penetration depth. General spot friction stir welding tool consists of a shoulder having bigger diameter and a threaded pin projected from the shoulder, which resulted in the generation of large up-lifting of upper plate around the weld nugget because of the deeper penetration and the severe stirring effect of threaded pin. Two kinds of welding tools without the threaded pin were used to avoid the distortion and improve the joint strength. One was a simple cylindrical shape and the other was cylindrical shape with small projection. Therefore, the process was named as spot friction welding comparing to spot friction stir welding because spot friction welding don't use a stirring effect. Using the cylindrical shape tool with small projection, the up-lifting of upper plate were avoided and joint strength were superior to that of the joint using simple cylindrical shape tool. At the 0.5mm of too penetration depth using cylindrical tool with small projection, nugget pull fracture mode can be observed and shear fracture mode were dominant at the rest conditions.

키워드