Proceedings of the Korean Society of Precision Engineering Conference (한국정밀공학회:학술대회논문집)
- 2001.04a
- /
- Pages.1076-1079
- /
- 2001
- /
- 2005-8446(pISSN)
A Study on the Grinding of Titanium Alloy, Part2 : Grinding characteristics by using Superabrasives
티타늄 합금의 연삭에 관한 연구, Part2 : 초연마재를 사용한 연삭특성
- Kim, S. H. (Dept. of Eng. Sci. Mech., KNUT) ;
-
Choi, H.
(Dept. of Mech. Eng., KNUT)
;
-
lee, J. C.
(Dept. of Mech. Eng., KNUT)
;
-
Cheong, S. H.
(Dept. of Mech. Eng., KNUT)
- Published : 2001.04.01
Abstract
This investigation reports the grinding characteristics of titanium alloy(Ti-6Al-4V). Grinding experiments were performed at various grinding conditions. The grinding forces and grinding force ratio were measured to investigate the grindability of titanium alloy with the Diamond and CBN wheel. To investigate the grinding characteristics of titanium alloy grinding force ratio and grinding ratio were measured. Surface profile of wheel was also measured with tracer and the ground surfaces and chip were observed with SEM. Grinding-ratio of titanium alloy was much lower than that of other materials. Grinding-ratio of titanium alloy with Diamond wheel was almost six times larger than that with CBN wheel.
Keywords