Electrical and Mechanical Properties of Semiconducting Shield for Power Cable by Carbon Nanotube Content

탄소나노튜브(CNT) 함량에 따른 전력케이블용 반도전 재료(층)의 전기적/기계적 특성 연구

  • 양종석 (원광대 전기전자및정보공학부) ;
  • 이경용 (원광대 전기전자및정보공학부) ;
  • 신동훈 (원광대 전기전자및정보공학부) ;
  • 박대희 (원광대 전기전자및정보공학부)
  • Published : 2006.08.01

Abstract

In this study, we have investigated electrical and mechanical properties of semiconducting materials for power cable caused by CNT. Specimens were made of sheet form with the four of specimens for measurement. Volume resistivity of specimens was measured by volume resistivity meter after 10 minutes in the pre-heated oven of both $23{\pm}\;1\;[^{\circ}C]\;and\;90{\pm}\;1\;[^{\circ}C]$. And stress-strain of specimens was measured by TENSOMETER 2000. A speed of measurement was 200[mm/min], ranges of stress and strain were 400[Kgf/Cm2] and 600[%]. From this experimental results, the volume resistivity had different properties because of PTC/NTC tendency at between $23[^{\circ}C]\;and\;90[^{\circ}C]$. Also volume resistivity was low by increasing the content of CNT. It means that a small amount of CNT has a excellent electrical properties. And stress was increased, while strain was decreased by increasing the content of CNT. Thus, we could know that a small amount of CNT has a excellent electrical and mechanical oroperties.

Keywords

Semiconducting Materials;CNT;EEA;Volume Resistivity;Stress-Strain

References

  1. 김현철, '탄소나노튜브를 첨가한 나노 복합재료의 기계적/물리적 특성 변화 연구' pp. 1-2, 2002
  2. Standard Test Method for Rubber Property-Volume Resistivity of Electrically Conductive and Antistatic Products, Annual Book of ASTM Standards D991, Vol. 08.01, pp. 172-176, 1998
  3. 김성철 외,고분자공학I,회중당,1994,pp. 2-337
  4. Standard Test Method for Tensile Properties of Plastics, Annual Book of ASTM Standards 638, Vol. 08.01, pp. 52-64, 1998
  5. 한재홍, 김상준, 권오형, 강희태, 서광석, '반도전층 내 불순물이 전력케이블의 신뢰도에 미치는 영향' 대한전기학회 논문지,Vol. 46, No.1,pp. 19-27, 1997
  6. S. A. Boggs, M. S. Mashikian, 'Role of Semoconducting Compounds in Water Treeing of XLPE Cable Insulation', IEEE Electrical Insulation Magazine, Vol. 10, No.1, pp. 23-28, 1994 https://doi.org/10.1109/57.259979
  7. 한재홍, 임장섭,이동영,'전력케이블용 반도전 재료의 설계기술' 한국전기전자재료학회 논문지,Vol. 13,No.2,pp. 12-17,2000
  8. J. Hjerrild, J. Holboll, M. Henriksen, S. Boggs, 'Effect of semicon-dielectric interface on conductivity and electric field distribution', Dielectrics and Electrical Insulation, IEEE Transactions on, Vol. 9, No.4, pp. 596-693, Aug. 2002 https://doi.org/10.1109/TDEI.2002.1024438
  9. Technical Report S-39, 'Conductive Carbon Black in Plastics', Cabot Corporation
  10. S. S. Bamji, A. T. Bulinski, R. J. Densley, M. Matsuki, 'Degradation mechanism at XLPE/semicon interface subjected to high electrical stress', Electrical Insulation, IEEE Transactions on, Vol. 26, No.2, pp. 278-284, April 1991 https://doi.org/10.1109/14.78329
  11. S. A. Boggs, '$500{\Omega}$-m-Low Enough Resisitivity for a Cable Ground Shield Semicon?', IEEE Electrical Insulation Magazine, Vol. 17, No.4, pp. 26-32, 2001 https://doi.org/10.1109/57.948981
  12. 김재철, 이종훈, 남재도, 'HDPE 가교 결합과 계면 접착력에 변화에 따른 PTC 특성 변화', polymer(korea), Vol. 27, No.4, pp. 275-284, 2003
  13. 박수진, 송수완, 서민강, 이재락,'나노구조 카본블랙/HDPE 복합재료의 전기적 특성: 전자선 조사에 의한 PTe 특성변화',한국복합재료 학회지,Vol. 16,No.1,pp. 19-25,Feb. 2003
  14. 박수진, 석수자,이재락,홍성권,'오존처리에 따른 탄소 나노튜브 강화 고밀도 폴리에틸렌 기지 복합재료의 PTCINTC특성', polymer(korea), Vol. 29, No.1, pp. 32-35, 2005
  15. J. S. Yoon, S. H. Oh, M. N. Kim, I. J. Chin, Y. H. Kim, 'Thermal and mechanical properties of poly(l-lactic acid)-poly (ethyleneco-vinyl acetate) blendsl,' Polymer, Vol. 40, No.9, pp. 2303-2312, April 1999 https://doi.org/10.1016/S0032-3861(98)00463-7